Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Release Cylinder. Repair procedures / Removal

1.	Drain the brake fluid through the bleed plug (A).

2.

Remove the clutch release cylinder assembly (C) after removing thd tube (B) and nuts (A-2ea).

Tightening torque:

14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.9 ~ 15.9 lb-ft)

Clutch Release Cylinder. Repair procedures

...

Installation

1. Installation is the reverse of removal. Coat the clutch clevis push ro ...

See also:

Inspection
1. Check the driveshaft boots for damage and deterioration. 2. Check the driveshaft spline for wear or damage. 3. ...

Adjustment
ETC module learning procedure When installing new ETC module or re-installing it, ETC module learning procedure must be performed. 1. Hold the ignition k ...

Troubleshooting
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower ar ...

Hyundai Accent Manuals

© 2011-2025 Copyright www.hamanual.com