Hyundai Accent: Rear Axle Assembly

Reassembly

1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots. 2. Apply grease to the joint boot on the side of the wheel an ...

Rear Hub - Carrier. Components and Components Location

Components 1. Rear torsion beam assembly 2. Brake assembly 3. Rear wheel hub assembly 4. Rear brake disc 5. Rear brake disc mounting screw 6. Rear wheel / T ...

See also:

Inspection
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly distribute the sealant in the tire. Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...

SRSCM Connector terminal
Pin Function (Connector A) Pin Function (Connector B) 1 Ignition 1 Seat belt pretensioner [Drive ...