1. |
Fix the steering gear box assembly (A) on the vice.
|
2. |
Remove the bellows clip (A) in the direction of the arrow. (The
left and right same work.)
|
3. |
Give space to bellows bend (B) by using the ring pliers (A). (The
left and right same work)
|
4. |
After making the space to the bellows and tie-rod end contact
part by using the (-) driver, remove the bellows (A) in the direction
of the arrow.(The left and right same work)
|
5. |
Remove the tie-rod & tie-rod end assembly (A).(The left and right
same work)
|
6. |
After fixing the yoke plug (A), remove the rock nut (B).
|
7. |
Remove the yoke plug (A).
|
8. |
Remove the yoke spring (A) and leaf spring (B).
|
9. |
Remove the support yoke assembly (A) from the inner lack hosing.
|
10. |
Remove the dust packing & cap (A).
|
11. |
Remove the top plug (A) by using the spanner.
|
12. |
Remove the pinion assembly (A).
|
13. |
Remove the rack bar (A) in the direction of the arrow.
|
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Inspection
1.
Check the driveshaft boots for damage and deterioration.
2.
Check the driveshaft spline for wear or damage.
3.
...
Removal
1.
Make sure vehicle does not roll before setting room side shift
lever and T/M side manual control lever to "N" position.
2.
Rem ...