Hyundai Accent: Dimensions Projected
Hyundai Accent RB (2010-2018) Service Manual / General Information / Dimensions Projected
| 1. |
These are the dimensions measured when the measurement
points are projected from the vehicle's surface, and are the reference
dimensions used for used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable,
measure it by lengthening one of two probes as long as the different
value in height of the two surface.
|
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure there
...
Measuring Actual Dimensions
1.
These dimensions indicate the actual linear distance
between measurement points, and are used as the reference dimensions
when a tracking gauge is used for measurem ...
See also:
Troubleshooting
Troubleshooting
1.
The lamp switch inputs can be checked using the GDS.
2.
To check the input value of lamp switch, select option "Body Co ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com