Hyundai Accent: Measuring Body Dimensions
Hyundai Accent RB (2010-2018) Service Manual / General Information / Measuring Body Dimensions
| 1. |
Basically, all measurements in this manual are taken
with a tracking gauge.
|
| 2. |
When a measuring tape is used, check to be sure there
is no elongation, twisting or bending.
|
| 3. |
For measuring dimensions, both projected dimensions
and actual - measurement dimensions are used in this manual.
|
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or
tubing.
...
Dimensions Projected
1.
These are the dimensions measured when the measurement
points are projected from the vehicle's surface, and are the reference
dimensions used for used for body ...
See also:
Installation
1.
Installation is the reverse of removal.
2.
Use a SST (09580-0U000) when installing the brake caliper assembly.
...
Reassembly
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
2.
Apply grease to the joint boot on the side of the wheel an ...
Replacement
1.
Turn ignition switch OFF.
2.
Disconnect the negative (-) battery cable.
3.
Disconnect the TCM connector (A ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com