Hyundai Accent Manuals

Hyundai Accent: Inspection - Timing Chain. Repair procedures - Timing System. - Engine Mechanical SystemHyundai Accent: Inspection

Sprockets, Hydraulic Tensioner, Chain Guide, Tensioner Arm
1.
Check the CVVT sprocket, crankshaft sprocket teeth for abnormal wear, cracks or damage. Replace if necessary.
2.
Check a contact surface of the chain tensioner arm and guide for abnormal wear, cracks or damage. Replace if necessary.
3.
Check the hydraulic tensioner for its piston stroke and ratchet operation. Replace if necessary.
Belt, Idler, Pulley
1.
Check the idler for excessive oil leakage, abnormal rotation or vibration. Replace if necssery.
2.
Check belt for maintenance and abnormal wear of V-ribbed part. Replace if necssery.
3.
Check the pulleys for vibration in rotation, oil or dust deposit of V-ribbed part. Replace if necssery.
•
Do not bend, twist or turn the timing belt inside out.
•
Do not allow the timing belt to come into contact with oil, water and steam.

Removal
Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted ...

Installation
1. Dowel pin of crankshaft should be positioned at 3° in relation to vertical center line. 2. Align the TDC marks (A) of the CVVT ...

See also:

Low tire pressure telltale
When the tire pressure monitoring system warning indicator is illuminated, one or more of your tires is significantly under-inflated. If the telltale illuminates, immediately reduce your speed, a ...

To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch is ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com