Hyundai Accent: Inspection
Radiator Cap Testing
| 1. |
Remove the radiator cap, wet its seal with engine
coolant, then install it on a pressure tester.
|
| 2. |
Apply a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm²,
13.51 ~ 17.78psi).
|
| 3. |
Check for a drop in pressure.
|
| 4. |
If the pressure drops, replace the cap.
|
Radiator Leakge Test
| 1. |
Wait until engine is cool, then carefully remove
the radiator cap and fill the radiator with engine coolant, then install
it on the pressure tester (A).
|
| 2. |
Apply a pressure tester to the radiator and apply
a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm², 13.51 ~ 17.78psi).
|
| 3. |
Inspect for engine coolant leaks and a drop in pressure.
|
| 4. |
Remove the tester and reinstall the radiator cap.
|
Removal and Installation
1.
Disconnect the battery terminals. (Refer to Engine
and transaxle assembly in this group)
2.
Remove the air cleaner assembly. (Refer to E ...
See also:
Inhibitor Switch. Description and Operation
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control
gear setting signals.
...
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back
for low beams.
The high beam indicator will light when the headlight high beams are switched
on.
To prevent the ...
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch fl ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com