Hyundai Accent: Installation| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes.
|
| 3. |
Tighten the curtain airbag mounting bolts.
|
| 4. |
Connect the curtain airbag connector.
|
| 5. |
Install the roof trim.
(Refer to the Body group - "Interior")
|
| 6. |
Reconnect the battery negative cable.
|
| 7. |
After installing the curtain airbag (CAB), confirm proper system
operation:
|
Removal
Airbag Module Disposal. Description
and OperationComponents and Components Location
Components Location
1. PCV valve
2. Canister
3. Purge control solenoid valve (PCSV)
4. Fuel tank pressure sensor (FTPS)
5. Canister close valve (CCV)
6. Fuel ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Specifications
Specifications
Direct control VFS[UD/B]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.5 ~ 0.1, 7.82 ~ 1.42) ...
Rear Body ( 5Door )
Side outer panel rear corner
Tail gate hinge mounting hole (Ø14)
Tail gate hinge mounting hole ...