1. |
Disconnect the battery negative cable and wait for at least 3
minutes before beginning work.
|
2. |
Remove the roof trim.
(Refer to the Body group - "Interior")
|
3. |
Disconnect the curtain airbag harness connector.
|
4. |
After loosening the mounting bolts remove the curtain airbag.
|
Rear Glass Defogger Printed Heater. Repair procedures
Inspection
Wrap tin foil around the end of the voltmeter test lead to prevent
damaging the heater line. Apply finger pressure ...
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine
coolant, then install it on a pressure tester.
2.
Ap ...
Inhibitor Switch. Description and Operation
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control
gear setting signals.
...