Hyundai Accent Manuals

Hyundai Accent: Installation - Transaxle Control Module (TCM). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Control Module (TCM). Repair procedures / Installation

1.
Installation is reverse of removal.
In the case of the vehicle equipped with immobilizer or button engine start system, perform "Key Teaching" procedure together (Refer to "Immobilizer" or "Button Engine Start System in BE group).

Replacement
1. Turn ignition switch OFF. 2. Disconnect the negative (-) battery cable. 3. Disconnect the TCM connector (A ...

Transaxle Oil Temperature Sensor. Description and Operation
Description Transaxle oil temperature sensor monitors the automatic transaxle fluid's temperature and conveys the readings to TCM. It is an NTC (Negative Thermal Coefficient) sensor whos ...

See also:

Wheel. Repair procedures
Hub Nut Tightening Sequence Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Engine Coolant Temperature Sensor (ECTS). Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...

Immobilizer Control Unit. Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to the BD group - "Crash ...

Hyundai Accent Manuals

В© 2011-2026 Copyright www.hamanual.com