1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
3. |
Disconnect the connectors and remove the BCM (A) after loosening
2 bolts.
|
Adjustment
Adjusting the control cable
1.
Set room side AT lever(shift lever) and automatic transaxle side
manual control lever to "N" position.
2. ...
Precautions For Catalytic Converter
If a large amount of unburned gasoline flows into
the converter, it may overheat and create a fire hazard. To prevent
this ...
Reassembly
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
2.
Apply grease to the joint boot on the side of the wheel an ...