Hyundai Accent Manuals

Hyundai Accent: Removal - Seat Belt Pretensioner (BPT). Repair procedures - Seat Belt Pretensioner - Restraint (Depowered)Hyundai Accent: Removal

1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the lower anchor bolt.
3.
Remove the following parts.
(Refer to the Body group - "Interior trim")
A.
Door scuff trim
B.
Center pillar trim
4.
Remove the upper anchor bolt.
5.
Disconnect the seat belt pretensioner connector (A).

6.
Loosen the seat belt pretensioner mounting bolts (B,C) and remove the seat belt pretensioner.

Seat Belt Pretensioner (BPT). Repair procedures
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes. ...

See also:

Wheel nut tightening torque
Steel wheel & aluminum alloy wheel: 65~79 lb·ft (9~11 kg·m) If you have a tire gauge, remove the valve cap and check the air pressure. If the pressure is lower than recommended, drive slowly ...

Installation
1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting ( ...

Reporting safety defects
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com