Hyundai Accent Manuals

Hyundai Accent: Replacement - Front Strut Assembly. Repair 
procedures - Front Suspension System - Suspension SystemHyundai Accent: Replacement

1.
Remove the front wheel & tire.

Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Remove the brake hose (A) and the wheel speed sensor bracket(B) and wheel speed sensor (C) from the front strut assembly by loosening the mounting bolts.

Tightening torque :
(B,C) 7.8 ~ 11.8N.m(0.8 ~ 1.2kgf.m, 5.8 ~ 8.7lb-ft)

3.
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Loosen the strut mounting nut (A).

Tightening torque :
49.0 ~ 58.8N.m(5.0 ~ 6.0kgf.m, 36.2 ~ 43.4lb-ft)

5.
Disconnect the front strut assembly (A) with the front axle (B) by loosening the bolt & nut.

Tightening torque :
137.3 ~ 156.9N.m(14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)

6.
Installation is the reverse of removal.
•
Tighten with specifed torque at curb position of vehicle
•
Fix the strut rod and tighten the nut

Front Strut Assembly. Repair procedures
...

Disassembly and Reassembly
1. Compress the coil spring with a strut spring compressor. Do not compress the spring more than necessary. 2. Loosen the lock nut. ...

See also:

Installation
1. Reassemble the hands free switch after connecting the connector. 2. Reassemble the steering wheel. 3. Reasse ...

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Installation
Installation is in the reverse order of removal. Perform the following : • Adjust a shift cable. • Refill engine with engine oil. ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com