Hyundai Accent: Inspection
| 1. |
Check the bushing for wear and deterioration.
|
| 2. |
Check the front stabilizer bar for deformation.
|
| 3. |
Check the front stabilizer link ball joint for damage.
|
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Sub Frame. Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
See also:
Crankshaft Position Sensor
(CKPS). Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS)
and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection
and ignition timing by using ...
Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety
location.
2.Connect connection hose (9) of the compressor directly to the tire valve.
3.Plug the compressor power c ...
To resume cruising speed at more than approximately 25 mph (40 km/h)
If any method other than the cruise ON/OFF switch was used to cancel cruising
speed and the system is still activated, the most recent set speed will automatically
resume when the RES+ switch is ...
Hyundai Accent Manuals
