Hyundai Accent: General
| 1. |
Basically, all measurements in this manual are taken with a tracking
gauge.
|
| 2. |
When a measuring tape is used, check to be sure there is no elongation,
twisting or bending.
|
| 3. |
For measuring dimensions, both projected dimension and actual-measurement
dimension are used in this manual.
|
Measurement Method
Projected Dimensions
1.
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions ...
See also:
Replacement
Front Door Trim Replacement
•
Be careful not to scratch the door trim and other parts.
...
Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the mu ...
TCM Terminal Input/ Output Signal
Connector [CHG-AA]
Pin
Description
Condition
Input/output value
Type
Level
22
Overdrive clutch c ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com